Rousseau 2600 PortaMax Jr. Table Saw Table Top and Fence System

August 1, 2013 - Comment

Product Features Increases rip capacity of bench top table saws to 24-1/2-inches Ideal for those with limited space PM2720 outfeed can be used with this system when PM2600 is mounted to stand Comes with both a short and long leg 8-1/2-inch cam securely locks to front rail Delta Shopmaster TS 200 Fits: Delta 34-330, 36-275,

Buy Now! $219.00Amazon.com Price
(as of April 19, 2020 12:01 pm CDT - Details)

Product Features

  • Increases rip capacity of bench top table saws to 24-1/2-inches
  • Ideal for those with limited space
  • PM2720 outfeed can be used with this system when PM2600 is mounted to stand
  • Comes with both a short and long leg
  • 8-1/2-inch cam securely locks to front rail
  • Delta Shopmaster TS 200
  • Fits: Delta 34-330, 36-275, 36-510, 36-540
  • Makita 2702, 2703, 2708
  • Ryobi BT2500
  • Saws with tops up to 22″ x 26-5/8″
  • Skil 3400

Comments

William W Witman says:

PortaMax Jr, turns portable tabel saw into contractor’s saw Adding the PortaMax Jr to your 8-1/4″ or 10″ Bench-top table saw gives you an accurate saw with a precise rip fence, equal to many higher priced Table Saws. Allow ripping a full 4X8 sheet of plywood lengthwise. This accesory is easy to install and Rousseau provides prompt replies to any questions that arise during installation.

David Wheaton says:

Portamax JR PM2600D, You Bet! Easy to install and easy to adjust. Although not noted in the writeup, the Portamax JR PM2600D is a direct bolt up for the Makita 2703 XL table saw. This makes this saw 1) accurate and #2)enable a 24″ rip. This allows the accuracy of the rousseau table, but also allows you to use the stand that comes with the Makita 2703 XL saw. I would recommend this unit to anyone.

B. Dowling says:

Doubles the value and usefulness of your portable saw! I bought this table extension and fence for my Makita 10″ portable table saw. The Makita came with a terrible fence that was almost always off-center and inaccurate. Even worse, the table was so small, you could only make cuts up to 12″ wide. This table extension makes the saw able to rip full size sheet goods (the long way) and the fence makes the Makita a decently accurate saw to work with. So far I’ve used this combination for making speaker cabinets and homebrew arcade…

Write a comment

*

--- Terms of Use --- Privacy Policy --- Amazon Affiliate --- Affiliate Disclosure --- FTC Statement --- Contact