Kreg KMA2675 Kreg Rip-Cut

August 4, 2013 - Comment

Ripping down large panels into smaller more manageable workpieces is one of the trickiest, most intimidating, and expensive steps of any wood project. Even if you’re ripping with the nicest table saw, you’re still forced to lift large heavy panels, balance them carefully to avoid binding and bowing, while at the same time trying to

Buy Now! $47.96Amazon.com Price
(as of April 20, 2020 12:01 am CDT - Details)

Ripping down large panels into smaller more manageable workpieces is one of the trickiest, most intimidating, and expensive steps of any wood project. Even if you’re ripping with the nicest table saw, you’re still forced to lift large heavy panels, balance them carefully to avoid binding and bowing, while at the same time trying to support the finished workpieces and waste material as they exit the saw. There is a faster way. There is an easier way! There is a better way. Introducing the all-new Kreg Rip-Cut. The Rip-Cut is an incredibly handy tool which speeds and simplifies the process of ripping down large plywood and MDF panels. No measuring, no marking, no chalk lines-the Rip-Cut quickly and easily attaches to almost any circular saw, letting you cut pieces from 1/8-Inch up to 24-Inch wide with tremendous accuracy. The Rip-Cut is a no-nonsense, straight forward, accessory for your circular saw. It features a durable design including a solid aluminum guide rail, an easy-to-read adjustable scale, and a reversible guide arm which works whether you’re left or right handed and whether your blade is on the left or right side of the saw. It’s an incredibly easy, precise, and affordable way to break down large panels for almost any project.

Product Features

  • Connects to most circular saws-right or left blade
  • Reversible Guide Arm for Right or Left Hand Use
  • Rips cuts from 1/8-Inch to 24-Inch wide
  • No measuring, marking, and no chalk lines
  • 100-Percent Guide support through entire cut

Comments

Texian says:

Another Fine Tool Aid by Kreg Having purchased and owned several Kreg products in the past, I was not hesitant to try the Rip Cut by Kreg. As a casual observer, I could tell that the intent of this product was to allow the user to adapt their own saw to the tool, cut straight rips through sheet products and most of all, do so without the use of a pencil or straight edge or even tape measure.With all Kreg products, you will find that the Rip Cut comes in a good package with all loose items secured in heavy bags…

orangekay says:

Better than most, but far from perfect Compared to those overpriced plastic T-squares that pass as rip guides, this thing is a lot better in many ways–it’s more accurate, a whole lot sturdier, and it works no matter which direction your blade faces.Assembly is surprisingly complicated. It shouldn’t be beyond you if you do a lot of building, but I have absolutely no idea why the little plastic clamping thing with all the little parts couldn’t be pre-assembled in the package.Attaching it to the saw involves…

D. Middleton says:

A Great Plan “B” When There is No Table Saw. Senior Engineering Students had the table saw fail during a project. They were, “not so good”, at telling a technician about the problem. When I arrived needing to rip two sheets of plywood I stood in awe of there inability to communicate. The fact the saw broke is due probably to normal wear. The fact the problem went unreported by SENIOR ENGINEERING STUDENTS….Plan “B” was the Kreg Rip-Cut. It went together quickly. It worked perfectly. I have one wish and one recommendation…

Write a comment

*

--- Terms of Use --- Privacy Policy --- Amazon Affiliate --- Affiliate Disclosure --- FTC Statement --- Contact