Bosch DC010 Digital Carriage Display for 4100-series Table Saws

Includes Digital Carriage Display for 4100-Series Table Saws – DC010

Product Features

  • Ultimate Precision – Digital readout complements best-Inch class rip fence – Digital Accessory Kit available as upgrade for 4100 & 4100-09
  • Accurate to 1/32-Inch – Readout displays-Inch-increments of 1/8-Inch, 1/16-Inch, 1/32-Inch and metric up to .5mm
  • Enhanced Productivity – High visibility LCD for ease of readability
  • Faster set up for repetitive cutting – Reduces material waste by taking out the guesswork
  • Jobsite Tough – Robust cast aluminum design withstands jobsite abuse and weather

2 thoughts on “Bosch DC010 Digital Carriage Display for 4100-series Table Saws

  1. Easy add-on, works great I bought the 4100 saw without the digital readout and wanted to add this feature, so when it became available, I purchased it. It is a very well constructed piece of equipment as most Bosch stuff is. The assembly was simple and the instructions were clear and it was easy to attach to the saw. The readout is large enough to see easily and bright enough for work outside. Easy to zero and then set your rip dimension. It works really well and allows a reading for a wide rip with the sliding table…

  2. A MUST have for your 4100-09 Table Saw! This is the EXACT same unit that comes with the 4100DG-09 table saw for $100 more. It works flawlessly and the installation takes about 10-minutes.The directions for installation are pretty clear, but could be improved. Nonetheless, it was a painless install and I saved $100 by ordering the base 4100-09 and the DG separately.The unit is deadly accurate and can be set to increments as low as 1/32.As far as I’m concerned, this is a MUST purchase for Bosch 4000…

Leave a Reply

Your email address will not be published. Required fields are marked *