# Arbor Diameter: 12mm
# Diamond blade cut width (kerf): 0.033″(0.83mm)
# Carbide blade cut width (kerf): 0.073″(1.85mm)
# Maximum Depth of Cut: 5/8″
# Motor : 0.8Amp, 4500 RPM
# Blade Cover Assembly
# Instruction Manual
# Dimensions: 4 1/2″ x 5 1/2″ x 7″
Product Features
- Includes Two Blades: 24 Tooth Carbide Tip Blade & Diamond Coated Tile Blade
- Wobble-free blade design for precision cuts
- Tool-free hand adjustable table height
- Sliding cross cut guide bar with 2 table channels
- Improved blade guard
Light work OK, BEWARE OF INJURY I needed this for a project using acrylic. It works fine. I doubt whether it would work for heavy stock, but I expect it was not designed for that anyway.DESIGN HAZARD ALERT:However, I cut my finger on the saw blade because there is an opening underneath the table and to the rear of center on either side. I had turned off the saw and was moving it when I stuck my left index finger into the gap and it contacted the still spinning blade! Fortunately, it was not deep but it was a…
Nice little saw 0